GENTLE NON INTRUSIVE TEMPERATURE MEASUREMENT\n 1 SECOND QUICK MEASUREMENT\n 2 MODE - SILENT & BUZZER-BEEP\n LAST READING RECALL\n TOUCH FREE, EASY TO USE\n BACK LIGHT FOR EASY READING\n 25 MEMORIES STORAGE\n LCD SCREEN\n2.1 Removing the Insulating Tape\nWhen using the thermometer for the first time, pull the\ninsulating tape out of the battery compartment.\nThe unit is turned on and after 1 minute the room temperature\nappears on the display.\nNotes:\n• The room temperature remains on the display even after the unit turns off.\n• Place the unit on a level surface, in a place that is at room temperature (away from direct sunlight or air conditioning, etc.).\n2.2 Switching between °C and °F\nThis unit is set in °C as default.\n1. While the room temperature is displayed, press and hold the START button.\n2. While holding it down, press and hold the ON/MEM\nbutton until °F appears on the display with two beeps.\nNotes:\n• To select °C mode again, start from step1.\n• When the unit is switched between °C and °F, all the readings stored in the\nmemory are deleted.\nTaking a Reading\nForehead Measurement Mode\nThis mode displays the oral-equivalent value of the measured forehead temperature.\nAlways make sure the probe lens is clean and undamaged, and the forehead is clean with no sweat, cosmetics,\nscars, etc.\nPrior to measurement, ensure that the patient has not taken a bath or exercised within the last 30 minutes, and\nhas remained in a stable environment for at least 5 minutes.\nIt is recommended to perform measurement three times. If the three measurements are different, select the\nhighest temperature.\n1. Pull off the probe lens cap to remove it.\n2. Press the ON/MEM button.\nAll indicators appear on the display for 1 second.\nThen the display shown on the far right appears with two beeps.\n3. Hold the probe lens 1 to 3 cm away from the center of the\nforehead.\nNotes:\n• Holding the unit too long in the hand may cause a higher ambient temperature reading of the\nprobe. This could make the body temperature measurement lower than usual.\n• Keep still during measurement.\n4. Press the START button.\nThe measurement is complete in 1 second with a long beep.\n5. Move the unit away from the forehead and check the\nmeasurement result.\nThe display lights up for 5 seconds.\nNotes:\n• If the result is higher than 42.2°C (108.0°F), “Hi” appears on the display.\nIf the result is lower than 34.0°C (93.2°F), “Lo” appears on the display.\n• You can take another measurement after the display light turns off with two\nbeeps. Make sure the “ ” icon remains lit.\n• After the second measurement, the first measurement is displayed in the right\ncorner, while the second is displayed in the center.\n6. Press and hold the ON/MEM button until “OFF” appears on the display to\nturn off the unit.\nThe unit stores the measurement in memory, then turns off with the room temperature on the display.\nThe unit also turns off automatically if no operation is performed for 1 minute.